Building Childrens Furntiture

Screws driven into the end grain of ply-wood should be long enough to take a 3/4-inch bite into the wood. Longer screws will not add materially to the strength of the joint and may split the wood.

Screws driven into core stock or solid wood should take a 1-inch bite-but to prevent splitting, a pilot hole, half the diameter of the screw, should be drilled first in the solid wood.

Screws driven into exposed surfaces of the project should be concealed with long-grain wood plugs as shown in the photos. These plugs are cut as needed from the sides of scrap wood with a special 1/2-inch plug cutter. They differ from dowels in that their ends have the grain pattern running across the surface, while dowels have an end grain.

The advantages of long-grain plugs are many. They can be cut from wood that matches in color and grain pattern the surface being plugged, and when properly matched and fitted they be-come almost invisible in the finished piece. Plugs take stain finishes in the same shade as the surrounding wood, while dowels, with their end grains, soak up the stain and appear considerably darker than the surrounding wood.

Dowels used as plugs may in time distort due to their failure to shrink and expand in the same direction as the wood which holds them. Plugs, however, will expand and contract in the same way as the wood. Finally, if for any reason a plug must be removed later, it can be chipped out easily with a 1/4-inch chisel, while the only way a dowel can be removed is to drill it out.

Recommended Reading

1. Building Childrens Furntiture
ALTHOUGH there are many ways to build good furniture, some requiring skills and equipment well beyond the reach of the...
2. Building Childrens Furntiture
In some cases plywood is more expensive than solid wood, but this is not usually the case. In fact, in...
3. Building Childrens Furntiture
To simplify construction procedure with-out sacrificing strength, dowel assembly is avoided in favor of screws and glue. Nails should never...
4. Building Childrens Furntiture
Some pieces shown in this book have rabbets or grooves that do not run the full length of the wood...
5. Building Childrens Furntiture
Having glued and joined all T's and L's, the next step is to assemble these joined sections together to complete...